Denford Software & Machines

Hello, Everyone.
I'm a new user, and this is my first post in this forum.

I have a Denford orac lathe.
I would like to program using the RS 232 option, using the old IBM software, but I
have no hints as to the format that must be used.
I would appreciated any input from other users.
A simple sample program, showing this type of programming format would be a good start.

Regards

Hi - It's not something I'm familiar with, but there has been some previous discussion on the Orac and downloading programs, some of these posts quote programming examples which look to me like standard G code format...

viewtopic.php?f=4&t=2043
viewtopic.php?f=4&t=1886
viewtopic.php?f=4&t=578
viewtopic.php?t=459

Thanks.

Seems to be a lot of info in here. I will take my time an read it through.

Best regards