Denford Software & Machines

Hi again,
Yesterday when I went to click on the VR milling icon it asked me to register it, I had with the floppy in the past. I went through the upgrade reg. process and put in the floppy. It found the sec. file but then kept saying not registered and terminating. Im using V5. Can you help.
Thanks

Try using regrights - see the last post in this thread:
viewtopic.php?f=8&t=2321

Because, on all the Denford latest types software i.e. VR Milling, VR Turning, Quickcam Pro etc, the security codes all have the same file name i.e. SecKey.tff. If you use Regrights it will tell you what Denford software the SecKey.tff is registered for and the number of licence(s)