Hi,
I have recently aquired a Starturn 4, it runs off a BBC. I was wondering if anyone out there had software, and lead connection wiring diagram. My intention is to try to get it going, just to see what it was like.
I currently have a Starturn 5, and an Orac which I am in the process of converting to Mach.
So if anyone can help with the Starturn 4, I would be ever so gratefull.
Regards,
Rob.
Starturn 4 BBC Software
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Did it come with the original BBC computer ?
If not then you may struggle - I believe there was an interface card or eeprom or something like that, which had to be installed into the BBC.
https://www.industrycommunity.com/manufa ... ges/3.html
If not then you may struggle - I believe there was an interface card or eeprom or something like that, which had to be installed into the BBC.
https://www.industrycommunity.com/manufa ... ges/3.html