Denford Software & Machines

hi to all
i recently bought a starmill 1990ish. it came with 3 sets of 5 1/4 floppies set1 denford 'starmill', set2 mastercam...lathe, set3 mastercam...milling.

is there anyone that can put the files onto 3 1/2 floppies/cd's, hopefully for £zero/£reasonable. i want to play around with the software to see if it will benefit me in any way. (starmill running on denfords 'dos' software). so i mainly want to try out the mastercam stuff.
regards baz

We can't do anything like that here, try these:
https://www.disk2disc.com/

If you have the mastercam dongle, you might be able to get the old s/w from them still ?