Denford Software & Machines

Dear All

I want to read and modify ladder from fanuc OM B and C. But I do not have Fapt ladder II. Can anybody help me out.

Best regards

I think we borrowed a programing unit to write the Fanuc Ladders on.

Not sure where it came from but pretty sure we have not had one for several years.

Martin wrote:I think we borrowed a programing unit to write the Fanuc Ladders on.

Not sure where it came from but pretty sure we have not had one for several years.

Thanks for your reply. I already had fapt ladder II and III

Regards

I've uploaded all that we have here:
viewtopic.php?t=1791

We used this version for the more recent 21i controls although I think it will go back to OT(M)-C - but you will need the eprom blower to plug into the PC.
For the OT(M)B controls we will have used the Fanuc PG-Mate programmer which I think is what Martin is on about.

Thanks for your reply

But your Fapt Laddder do not suport for PMC L and M if anybody need this software. This is link to dowload
viewtopic.php?t=1792

Denford Admin wrote:I've uploaded all that we have here:
viewtopic.php?t=1791

We used this version for the more recent 21i controls although I think it will go back to OT(M)-C - but you will need the eprom blower to plug into the PC.
For the OT(M)B controls we will have used the Fanuc PG-Mate programmer which I think is what Martin is on about.

Thanks for this.

BTW, how do you intend to blow the eproms ? Does this software give you a standard hex file that would allow any eprom blower to be used ? I always thought Fanuc would only ever allow their own blowers to be used (all at extortionate prices of course)

Denford Admin wrote:Thanks for this.

BTW, how do you intend to blow the eproms ? Does this software give you a standard hex file that would allow any eprom blower to be used ? I always thought Fanuc would only ever allow their own blowers to be used (all at extortionate prices of course)

You can buy from Korea
https://www.cadcam.co.kr/

Excellent ! - that link may well come in very handy one day..

Denford Admin wrote:Excellent ! - that link may well come in very handy one day..

Do you have programming manual for Fapt Ladder II and Fapt ladder II manual for PC.

We probably do but it will be subject to copyright.

We could not scan it.

I wrote two software on dos:
1.convert #ex ---> oe1,oe2 for writing eprom
2.convert oe1,oe2--->#ex for discompile and display ladder
https://www.cncb3h.com ydebin@yahoo.com

if using my converter software you can use general eprom w/r
to process fanuc pmc. ANd need not to use fanuc eprom w/r its too expensive and has to use a transformer from 220v to 100v.
ydebin@yahoo.com

hi first floor!

may be fanuc 0mb 0mc has two eprom chips. so it's used fapt ladder soware.
ladder ii is used for fanuc power mate d/h,and fanuc 15,16,18.