MasterCAM error
Posted: Fri 07 Dec , 2007 16:15 pm
Micromill 2000
When trying to run a .fnc file created in MasterCAM (designed in metric & following the instruction for the post process), We got an "Exceeds Limits" error. After checking offsets and everything , we noticed that the values of the X,Y, & Z moves where alot larger than the original design.
When trying to run a .fnc file created in MasterCAM (designed in metric & following the instruction for the post process), We got an "Exceeds Limits" error. After checking offsets and everything , we noticed that the values of the X,Y, & Z moves where alot larger than the original design.