IBM software for RS 232 connection

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Martin, Steve, Mr Magoo

Post Reply
KIoannidis
Posts: 5
Joined: Mon 09 Nov , 2009 10:58 am

IBM software for RS 232 connection

Post by KIoannidis » Tue 01 Dec , 2009 22:27 pm

Hello, Everyone.
I'm a new user, and this is my first post in this forum.

I have a Denford orac lathe.
I would like to program using the RS 232 option, using the old IBM software, but I
have no hints as to the format that must be used.
I would appreciated any input from other users.
A simple sample program, showing this type of programming format would be a good start.

Regards
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Re: IBM software for RS 232 connection

Post by Denford Admin » Wed 02 Dec , 2009 9:36 am

Hi - It's not something I'm familiar with, but there has been some previous discussion on the Orac and downloading programs, some of these posts quote programming examples which look to me like standard G code format...

viewtopic.php?f=4&t=2043
viewtopic.php?f=4&t=1886
viewtopic.php?f=4&t=578
viewtopic.php?t=459
Top
KIoannidis
Posts: 5
Joined: Mon 09 Nov , 2009 10:58 am

Re: IBM software for RS 232 connection

Post by KIoannidis » Thu 03 Dec , 2009 20:15 pm

Thanks.

Seems to be a lot of info in here. I will take my time an read it through.

Best regards
Top
Post Reply

Return to “Software”