"Line Should Start With A Keyword" Error

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

"Line Should Start With A Keyword" Error

Post by bradders » Tue 05 May , 2009 12:04 pm

Customer writes

In Quickcam Turning i get the error message

"Line Should Start With A Keyword"
Attachments
Line Should Start With A Keyword.JPG
Line Should Start With A Keyword.JPG (36.64 KiB) Viewed 3904 times
Top
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

Post by bradders » Tue 05 May , 2009 12:05 pm

From Admin

In the screen shot I can see it writing to D:\******* - is this accessible ?
Is the file C:\DENFORD\MACHDATA.INI read writable ?
Is this entry correct for the actual machine they are picking (eg Novaturn) ? :
..”The line that reads...
Novaturn (metric)=d:\denford\config\fanucl.ini
should read...
Novaturn (metric)=c:\denford\config\fanucl.ini
Does c:\denford\config\fanucl.ini exist ?

Get quickcam turning from here:
https://www.denfordata.com/downloads/Qui ... ing-CD.zip
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Wed 06 May , 2009 9:24 am

NB - QuickCAM turning is obsolete software now and has just been replaced by the brilliant QuickTURN 2D Design:
https://www.denford.ltd.uk/cataloguemay09/index16.html
Top
Post Reply

Return to “Software”