hi to all
i recently bought a starmill 1990ish. it came with 3 sets of 5 1/4 floppies set1 denford 'starmill', set2 mastercam...lathe, set3 mastercam...milling.
is there anyone that can put the files onto 3 1/2 floppies/cd's, hopefully for £zero/£reasonable. i want to play around with the software to see if it will benefit me in any way. (starmill running on denfords 'dos' software). so i mainly want to try out the mastercam stuff.
regards baz
5 1/4 floppies
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
We can't do anything like that here, try these:
https://www.disk2disc.com/
If you have the mastercam dongle, you might be able to get the old s/w from them still ?
https://www.disk2disc.com/
If you have the mastercam dongle, you might be able to get the old s/w from them still ?