CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.
Moderators: Martin, Steve, Mr Magoo
-
bradders
- CNC Guru
- Posts: 1251
- Joined: Mon 13 Feb , 2006 12:35 pm
- Location: Brighouse, England
-
Contact:
Post
by bradders » Tue 04 Sep , 2007 9:59 am
Can anyone provide a comprehensive list / cause of DOS Software Errors ?
Error 50 and 128 seem to be common
-
Mr Magoo
- CNC Guru
- Posts: 301
- Joined: Tue 21 Feb , 2006 21:45 pm
- Location: Brisbane, Australia
Post
by Mr Magoo » Tue 11 Sep , 2007 11:25 am
No.
These are magic numbers and have no logical rhyme or reason.
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
- Location: Sunny Brighouse
-
Contact:
Post
by Denford Admin » Thu 13 Sep , 2007 14:31 pm
Ha ha - the good old days of programming eh ? error codes without any meaning
-
bradders
- CNC Guru
- Posts: 1251
- Joined: Mon 13 Feb , 2006 12:35 pm
- Location: Brighouse, England
-
Contact:
Post
by bradders » Thu 13 Sep , 2007 14:34 pm
Admin - I still see you are keeping up the tradition
Champion, should just work !
-
Mr Magoo
- CNC Guru
- Posts: 301
- Joined: Tue 21 Feb , 2006 21:45 pm
- Location: Brisbane, Australia
Post
by Mr Magoo » Fri 14 Sep , 2007 4:07 am
One of my favourites...
Error 556: Unknown Error
Those were the days...
