We have an old Denford Micromill,serial #sp50901e, build date 8/99, control card #ds00217223.
What do I need to download from your DOS software to get this up and running again and is DOS Millcam available also?
Thank You
DOS Software for 1999 Micromill
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Have a look here:
viewtopic.php?t=856
Maybe its FanucSMD ?
Millcam was developed for windows (as far as I know), but there may have been a previous DOS equivalent - what about AutoCAM ? - I have seen that in the vintage section.
Its probably not worth pursuing a DOS CAM system - MillCAM will run on windows 95, and the DOS machine software will probably run quite happily from the same.
viewtopic.php?t=856
Maybe its FanucSMD ?
Millcam was developed for windows (as far as I know), but there may have been a previous DOS equivalent - what about AutoCAM ? - I have seen that in the vintage section.
Its probably not worth pursuing a DOS CAM system - MillCAM will run on windows 95, and the DOS machine software will probably run quite happily from the same.