I get this message when running CNC Simplified Multimedia
Error received when playing video. "Video not available. Cannot find VIDS.IV50 decompressor"
Video not available. Cannot find VIDS.IV50 decompressor
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
This indicates the file was compressed with a codec that is not installed on the computer.
In this case the codec VIDS.IV50 is Intel's Indeo Video Interactive 5 codec.
It's needed but wasn't found.
The solution is to install the Indeo Video Interactive codec on the particular machine generating the error.
In this case the codec VIDS.IV50 is Intel's Indeo Video Interactive 5 codec.
It's needed but wasn't found.
The solution is to install the Indeo Video Interactive codec on the particular machine generating the error.