FANUCMD DOS software - Prefixes not needed

CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:

FANUCMD DOS software - Prefixes not needed

Post by bradders » Tue 16 Apr , 2013 8:20 am

Customer writes...........

In FANUCMD DOS software

when I type a line of code. (N110 G90 G00 X10 Y10 Z-1 )

It comes up with a error that says. Prefixes not needed and the cursor high lights on the G of G00

User avatar
Denford Admin
Site Admin
Posts: 3642
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Re: FANUCMD DOS software - Prefixes not needed

Post by Denford Admin » Tue 16 Apr , 2013 8:57 am

I don't know how many G codes could be programmed on a single line in the DOS software - the current windows software only supports three IIRC
It'll be worth separating every G Code onto it's own line

Post Reply