VR Milling error "Invalid data field length for transaction"
Moderators: Martin, Steve, Mr Magoo
-
bradders
- CNC Guru
- Posts: 1251
- Joined: Mon 13 Feb , 2006 12:35 pm
- Location: Brighouse, England
- Contact:
VR Milling error "Invalid data field length for transaction"
VR Milling error "Invalid data field length for transaction"
-
bradders
- CNC Guru
- Posts: 1251
- Joined: Mon 13 Feb , 2006 12:35 pm
- Location: Brighouse, England
- Contact:
Re: VR Milling error "Invalid data field length for transact
Am sure its still a usb / noise fault
It just means USB data corruption
Try plugging your USB cable form the PC directly into the Baldor board, see if this solves the problem
It just means USB data corruption
Try plugging your USB cable form the PC directly into the Baldor board, see if this solves the problem
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: VR Milling error "Invalid data field length for transact
Also try running a program without the spindle running (either turn it off , remove the fuse or take the M03 out of the program)
If the program runs without any USB data corruption errors (like Timeout on ICM or invalid data field length) then it would indicate an earth problem or the spindle motor or drive is faulty - check the brushes
If the program runs without any USB data corruption errors (like Timeout on ICM or invalid data field length) then it would indicate an earth problem or the spindle motor or drive is faulty - check the brushes