Panning in 3D

Help and advice for Denfords lathe control software VR Turning.

Moderators: Martin, Steve, Mr Magoo

Post Reply
drb
Posts: 9
Joined: Sat 24 Feb , 2007 22:51 pm

Panning in 3D

Post by drb » Sun 25 Feb , 2007 3:28 am

After doing a 3D simulation in VR Turning for my Mirac, I can do everything but pan the image. I can zoom, rotate, slice, measure, but it won't pan. I am using the right mouse button and dragging left/right, but no pan. Any ideas? I know my right mouse button is working correctly since I am using it to zoom.
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Mon 26 Feb , 2007 14:18 pm

This should help:

VR Turning 3D simulation navigation buttons:

Hold LEFT mouse and drag left/right for rotate

Hold RIGHT mouse and drag up/down for zoom in/out

Hold LEFT and RIGHT mouse buttons and drag to pan left/right/up/down
Top
Post Reply

Return to “VR Turning - All Versions”