Back Again

Help and advice for Denfords lathe control software VR Turning.

Moderators: Martin, Steve, Mr Magoo

Post Reply
tecteach
Posts: 33
Joined: Tue 15 May , 2007 20:10 pm
Location: West Yorkshire

Back Again

Post by tecteach » Wed 25 Nov , 2009 17:30 pm

Hi, just a quick one, I am maching a 30mm aluminium piece and when I run a simulation in 3D & 2D it misses off the left hand part of the component ?
Please help
Why did I choose this profession, cos it aint for the money !

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Re: Back Again

Post by Denford Admin » Thu 26 Nov , 2009 9:55 am

This dosn't ring any bells as a common problem, can you post a screenshot ?

Post Reply