Baud Rate Number Unsupported
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Baud Rate Number Unsupported
We have seen the error Baud Rate Number Unsupported when trying to connect to a USB compatible Lathe (eg Turn270, Novaturn, MicroTurn)
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
I've found out that this happens (and will then continue to happen) if you try to connect the VR Turning software to a machine that it can't find (eg, the USB cable has been pulled out, or the machine is switched off)
To fix it, go into Setup > machine parameters and under communcation settings set the control type back to 9 (it will probably be set to something else like 11)
This won't happen in the next release of VR Turning v1.20
To fix it, go into Setup > machine parameters and under communcation settings set the control type back to 9 (it will probably be set to something else like 11)
This won't happen in the next release of VR Turning v1.20