Page 1 of 1
0 Feed Rate
Posted: Mon 04 Jun , 2007 15:22 pm
by msustudent
I have a Microturn 2000 and VRTurning Version 1.16.2.425. I was turning a piece of aluminum stock and took to big of a cut now my feed rate is 0% and when I try to turn a piece my spindle starts but the tool does not move. Do you have any suggestions to what the poblem is.
Thanks
Posted: Tue 05 Jun , 2007 7:57 am
by bradders
Does the axes HOME Ok ?
Posted: Tue 05 Jun , 2007 20:42 pm
by msustudent
Yes, it homes just fine. It turns out that the feedrate knob on the front of the lathe was turned down. All I had to do was turn the knob up and that solved my problem.
Thanks for the help.
Posted: Wed 06 Jun , 2007 14:11 pm
by bradders
