G01 problems remain after software upgrade.

Help and advice for Denfords lathe control software VR Turning.

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Fri 26 May , 2006 16:22 pm

RE the parameters - check that novaturn.ini is not read-only from windows file manager
(C:\Program Files\Denford\VRTurning\Config\NovaTurn.ini)
Also that you don't have the file open with another program, eg NotePad
You can edit parameters in the file directly if you have trouble doing it from VR Turning.


The cost of a new spindle encoder is around £150 plus P and P
Top
Post Reply

Return to “VR Turning - All Versions”