Help with Viceroy Lathe

Help and advice for Denfords lathe control software VR Turning.

Moderators: Steve, Mr Magoo, Martin, bradders

Post Reply
Posts: 3
Joined: Tue 08 Feb , 2022 16:47 pm
Hardware/Software: Vicroy TDS 1 PL GB

Help with Viceroy Lathe

Post by MediaMan » Thu 10 Feb , 2022 15:17 pm

Hi All

Please be gentle its my first time here, I have a Viceroy TDS Lathe, and i am replacing the variator that was fitted, but i have allways had a slight runout when turning a straight peice of metal, i have notice four large nuts above the motor holding the haed stock assy and presume these are for adjusting the head stock??, can any one give me advise on how to adjust run out.



User avatar
CNC Guru
CNC Guru
Posts: 1397
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

Re: Help with Viceroy Lathe

Post by Steve » Thu 10 Feb , 2022 17:19 pm

You may be better posting this in the Viceroy page on the forum.

Have you looked on that page?

Post Reply