Page 2 of 2
Re: Denford Quatro CNC Mill
Posted: Thu 12 Jul , 2012 22:29 pm
by bikermickyc
what is a good program to do the g codes edgecam art cam ? seen loads? do any run on an applemac ? if not we have pc's but prefer macs- Mike
Re: Denford Quatro CNC Mill
Posted: Thu 12 Jul , 2012 22:36 pm
by angel-tech
it's a shame they went down that route, the larger semco 800 and 1000 models i think have a ballscrew on the pillar. On my ones i've removed the quill travel and added a ballscrew to the pillar, making it into a vmc type mill.
Re: Denford Quatro CNC Mill
Posted: Fri 13 Jul , 2012 12:20 pm
by bikermickyc
Hi Thanks to Admin printed the Heidenhain manuals on the old laserjet 4000 (£10 for 4000 sheets! toners- cannot go wrong ) dread to think what it would cost on an inkjet-! many thans again-0 as you say seems quite straightforwards to use- Mike