Hi
I have Quatro mill with Heidenhain 355B control, it's been sitting around for a while and I would like to get it up and running,
I don't seem to have ant electical drawinings for the cabinet or the Heidenhain control parameters any assistance with these two topics would be greatly appreciated
Model QUATROMILL
Serial No QM03079 A
Despatch Date OCTOBER 1989
Serial No Of Electrics 2867431
Quatro Drwinings
Moderators: Martin, Steve, Mr Magoo
-
streethawk
- Posts: 3
- Joined: Tue 08 Nov , 2016 9:20 am
- Hardware/Software: Quatro mill
Triac mill
Cyclone lathe
Re: Quatro Drwinings
Hi Steve.
I can't locate the electrical drawings at present but hope this helps.
I can't locate the electrical drawings at present but hope this helps.
- Attachments
-
- PARAM-D.TXT
- (4.77 KiB) Downloaded 701 times
-
- heidenhain-tnc-355-operating-manual.pdf
- (10.74 MiB) Downloaded 1056 times
-
- Heidenhain TNC 351- 355 Service Manual.pdf
- (2.87 MiB) Downloaded 699 times
-
streethawk
- Posts: 3
- Joined: Tue 08 Nov , 2016 9:20 am
- Hardware/Software: Quatro mill
Triac mill
Cyclone lathe
Re: Quatro Drwinings
I appreciate the parameters and electrical drawings. I've input the parameters but when I start up it immediatley shows gross position error D, I've tried changing the values in MP57 and MP169 but all that seems to achieve is the Y axis lurging and a gross position error A occuring.Martin wrote:Hi Steve.
I can't locate the electrical drawings at present but hope this helps.
Any help or advise?