Spindle Question on a 1992 Triac p.c
Posted: Mon 06 Nov , 2023 19:34 pm
hi guys my first post here i am currently converting a 1992 Triac pc to mach 3 i have replaced stepper drives etc and proxy sensors for 3 wire type and everything except the spindle is working.... does anyone have a wiring diagram as to how this spindle can be wired into mach 3 it has a choke and a lenze 530 drive. The motor i believe is 180v dc and the lenze rectifies mains to this i believe..
any help would be greatly appreciated.
this is the board i am using 2 of these connected to two paralel ports on 1 pc
https://www.ebay.co.uk/itm/225799863242 ... gKv9fD_BwE
any help would be greatly appreciated.
this is the board i am using 2 of these connected to two paralel ports on 1 pc
https://www.ebay.co.uk/itm/225799863242 ... gKv9fD_BwE