Novamill stepper driver issue
Posted: Wed 21 Sep , 2022 11:56 am
Hey guys I’m looking for some suggestions on troubleshooting my issue further.
I purchased this cnc with unknown issues. The x axis stepper was jittering so I swapped the output between the x and y. The same stepper works on the y axis so it doesn’t appear to be an issue with the motor. I don’t see any visible damage to the control board - any suggestions on what I could test with my fluke or something to narrow down the issue? Thanks!
I gambled on purchasing vr milling and afraid I might have made the wrong decision.
I purchased this cnc with unknown issues. The x axis stepper was jittering so I swapped the output between the x and y. The same stepper works on the y axis so it doesn’t appear to be an issue with the motor. I don’t see any visible damage to the control board - any suggestions on what I could test with my fluke or something to narrow down the issue? Thanks!
I gambled on purchasing vr milling and afraid I might have made the wrong decision.