Baldor micro flex

Information and questions about Denford CNC Control electronics, general electrical issues, cables, diagrams, stepper motors, drives etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
sebson78
Posts: 3
Joined: Fri 19 Feb , 2021 10:26 am

Baldor micro flex

Post by sebson78 » Fri 19 Feb , 2021 12:47 pm

I'm in the process of configuring the servo drive and servo motor in the Mint Work Bench environment. There is a problem with the auto-tuning configuration;

(I will give some details)

-Windows 10 operating system

-Work Bench / Build number: 5860

-Servo drive. FMH 2A06TR-EN23

-Servo motor. BSM 80N-375 AF


Mint workbench informs that the motor encoder is not supported by the controller. I also fail

Feedbact test. In jog, the motor runs irregularly at lower revs, an overload fault occurs.
Overload error is very common. Status Led 8 or 5
I would like to ask for help and advice.

What firmware and how to properly upload it to the controller. I will provide more specific details when making contact.
20210214_145019~2.jpg
is it the fault of the wrong software
20210214_145019~2.jpg (692.36 KiB) Viewed 3098 times
20210218_190238.jpg
20210218_190238.jpg (153.66 KiB) Viewed 3098 times
20210218_190356.jpg
20210218_190356.jpg (595.52 KiB) Viewed 3098 times
Inked20210213_104442_LI.jpg
should I ignore this message
Inked20210213_104442_LI.jpg (1.01 MiB) Viewed 3098 times

Post Reply