Pin locations for X Y Z axes on Techcenter 21 Mill
Posted: Fri 26 Jul , 2013 15:37 pm
Hello,
I inherited a CNC Mill in my classroom that I understand from a previous email, you no longer support software for. I would like to run the machine with LINUX CNC but need Pin Output and Input specifications to complete the set up wizard and try it out.
It would also be helpful to know Motor Steps per Rev, Driver Microstepping, Leadscrew Pitch
If possible also the following:
Step Time
Step Space
Direction Hold
Direction Setup
Base Period Maximum Jitter
First Parport Base Address
...As well as any other information you think would be necessary/helpful.
Thanks!
I inherited a CNC Mill in my classroom that I understand from a previous email, you no longer support software for. I would like to run the machine with LINUX CNC but need Pin Output and Input specifications to complete the set up wizard and try it out.
It would also be helpful to know Motor Steps per Rev, Driver Microstepping, Leadscrew Pitch
If possible also the following:
Step Time
Step Space
Direction Hold
Direction Setup
Base Period Maximum Jitter
First Parport Base Address
...As well as any other information you think would be necessary/helpful.
Thanks!