stepper motors
Posted: Wed 10 Jul , 2013 21:50 pm
I am currently connecting new stepper drivers to my original motors, but as usual the denford gsm manual is not that forthcoming, I have also traced the wiring back to the motors but this has not resolved the issue as I was expecting there to be labelled connectors on the motors but instead the wire just split's and join's straight up to the motor coil's.
These are the stated connections from the denford manual-
Zph 1A
Zph 2A
Zph 1B
Zph 2B
Xph 1A
Xph 2A
Xph 1B
Xph 2B
Yph 1A
Yph 2A
Yph 1B
Yph 2B
Am I right to think 1A requires connection to A+ on my stepper driver and 2A requires connection to A- on my stepper driver..... and so on 1B to B+ and 2B to B-.
These are the stated connections from the denford manual-
Zph 1A
Zph 2A
Zph 1B
Zph 2B
Xph 1A
Xph 2A
Xph 1B
Xph 2B
Yph 1A
Yph 2A
Yph 1B
Yph 2B
Am I right to think 1A requires connection to A+ on my stepper driver and 2A requires connection to A- on my stepper driver..... and so on 1B to B+ and 2B to B-.