anyone have info on the dc motor used in the orac toolchanger
i'm looking at supplying a seperate dc supply , so wondered what volts / current rating it is
i presume the dc motor cover can be removed , although removing the 2 grub screws , i still cant slide the cover off
but just in case iv'e missed any other removal sequences , iv'e left it alone !
Orac Toolchanger dc motor spec ?
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3642
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Orac Toolchanger dc motor spec ?
It mentions it in here:
viewtopic.php?f=43&t=2963
MOTOR TRIDENT : 2332.912 11.151 000
Have you also checked the electrical drawings:
viewtopic.php?f=43&t=400
PS- there are two type of search - one at the top and one at the bottom of every page
viewtopic.php?f=43&t=2963
MOTOR TRIDENT : 2332.912 11.151 000
Have you also checked the electrical drawings:
viewtopic.php?f=43&t=400
PS- there are two type of search - one at the top and one at the bottom of every page