Denford Software & Machines

Posted: **Mon 04 Apr , 2011 15:54 pm**

Hello All,

Does anyone know of any circuit pinouts for the SMUC Driver connections?
This is on an old starmill it has 3 X L297 based Parker Digiplan Drivers that connect to a mother board that has screw terminals for motor connection and an IDC connector for step dir.

If anyone could let me know the step/dir and motor connections that would be most helpful.

Kind Regards,
SRG

Posted: **Mon 04 Apr , 2011 16:35 pm**

This might be relevant:

viewtopic.php?f=54&t=3272

Posted: **Mon 04 Apr , 2011 17:27 pm**

Thanks for the link!
It has helped with regards to main motor out pinout but unfortunately it doesn't mention anything about the step/dir pinouts which I believe are delivered through the connector X11!?

It appears this is an older version than the mill I have as it only mentions the number keypad whereas the Starmill I possess has the front panel with the LCD, encoder wheel, buttons and emergency stop button attached to it.

Kind Regards,
SRG

Posted: **Mon 04 Apr , 2011 17:42 pm**

Found the card Parker Digiplan sd2

Card info...
files/sd2_179.pdf

Denford Software & Machines

SMCU Starmill Stepper Board Pinout? (Dir / Step and motor)

SMCU Starmill Stepper Board Pinout? (Dir / Step and motor)

Re: SMCU Starmill Stepper Board Pinout? (Dir / Step and motor)

Re: SMCU Starmill Stepper Board Pinout? (Dir / Step and motor)

Re: SMCU Starmill Stepper Board Pinout? (Dir / Step and motor)