Denford Software & Machines

Posted: **Sun 08 Jul , 2007 22:20 pm**

I've just had another axis drive go down on my Orac lathe can these be repaired?

I'm sure I spoke to somebody at denford a while back and was told that it may be possible

Posted: **Mon 09 Jul , 2007 9:19 am**

Denford's cannot offer a repair service, but I know from previous posts on the forum that Parker offer a repair service as well as numerous other electrical companies

Posted: **Mon 09 Jul , 2007 11:29 am**

Parker digiplan are located in Poole Dorset.
Tel: 01202 699000

Posted: **Mon 09 Jul , 2007 19:59 pm**

Thats great news thanks both

Denford Software & Machines

Repairing axis drives

Repairing axis drives