How to change the Top Card on the NextMove controller.

Information and questions about Denford CNC Control electronics, general electrical issues, cables, diagrams, stepper motors, drives etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
Steve
CNC Guru
CNC Guru
Posts: 1451
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

How to change the Top Card on the NextMove controller.

Post by Steve » Fri 29 Jan , 2010 15:27 pm

The top card on all the controllers supplied from Smartstep, Denstep to NextMove can all be replaced in the same way.

Wether upgrading to a newer top card or fitting a service replacement the principle is the same.

Attached is a PDF booklet that tells you how to do this.

The PDF should be printed back to back then folded in half then stapled.
Attachments
Nextmove top card replacement.pdf
(519.49 KiB) Downloaded 1379 times
Top
Post Reply

Return to “Electronics”