USB to RS232 converter

Information and questions about Denford CNC Control electronics, general electrical issues, cables, diagrams, stepper motors, drives etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
candle
Posts: 3
Joined: Sat 29 Apr , 2006 22:40 pm
Location: Rana in Norway

USB to RS232 converter

Post by candle » Tue 28 Jul , 2009 17:06 pm

Hi,
I have a laptop which I want to connect to my Orac from 1983 for making/storing programs.
The laptop has only USB-ports and the Orac has seriel RS232 (?) port.

Is it possible to use a converter between the PC and Orac for for transferring data?
(In both directions)

Any suggestions for brand/type? Experiance?

Thanks for any hints.
Owner of Denford Orac lathe from 1983
Top
User avatar
Steve
CNC Guru
CNC Guru
Posts: 1449
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

Re: USB to RS232 converter

Post by Steve » Wed 29 Jul , 2009 7:44 am

Its all a bit hit and miss

We have found some work and others do not.

Any brand we would have tested will probably be obsolete. I am sure there is an artical on the forum about a recomended converter.

I think you just have to get one and try it out

Good Luck!
Top
User avatar
Denford Admin
Site Admin
Posts: 3642
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Re: USB to RS232 converter

Post by Denford Admin » Wed 29 Jul , 2009 11:02 am

Some previous discussion on USB>Rs232 devices:
viewtopic.php?f=4&t=1750&hilit=usb+rs232
viewtopic.php?f=4&t=2043&hilit=usb+rs232
Top
Post Reply

Return to “Electronics”