Hi
have a issue, after some troubleshooting , i have found out that most of my misery with the Mill, goes back to a Controller Card with intermitting faults. where some key functions not working.
i was thinking of changing this card.
but i'm at loss for which one to get. since its a fairly old machine the parts a expensive. so i was hoping for something in the line of retrofit of the card that works with rest of the machine, if not all, then most parts.
is there anyone that have done this before??
leaving some info of the mill
Triac Fanuc - ATC 1989
Moderators: Martin, Steve, Mr Magoo
-
bjornove
- Posts: 10
- Joined: Mon 11 Aug , 2014 10:25 am
- Hardware/Software: Model : Triac fanuc
Machine Serial No : E0 3543
Orginal customer : Bachke Maskin
Order No 3415
control supplier : Fanuc
Model : 0M-B
serial no : 8060460
Software version 0415-09
Triac Fanuc - ATC 1989
- Attachments
-
- IMG_20220118_094229.jpg (138.62 KiB) Viewed 11521 times
-
- IMG_20220118_094205.jpg (124.13 KiB) Viewed 11521 times
-
- IMG_20220117_194845.jpg (141.15 KiB) Viewed 11521 times