need your Denford 2000 input.
Have a Denford 2000 Mill.
The Baldor board burned out.
I want to replace it to make the axis spin again and the spindle work.
What will you recommend ?
Any comments highly appreciated
Denford 2000 Blown Baldor Board
Moderators: Martin, Steve, Mr Magoo
Denford 2000 Blown Baldor Board
Hi all,
need your Denford 2000 input.
Have a Denford 2000 Mill.
The Baldor board burned out.
I want to replace it to make the axis spin again and the spindle work.
What will you recommend ?
Any comments highly appreciated
need your Denford 2000 input.
Have a Denford 2000 Mill.
The Baldor board burned out.
I want to replace it to make the axis spin again and the spindle work.
What will you recommend ?
Any comments highly appreciated
-
pokerdetroit
- Posts: 4
- Joined: Mon 14 Oct , 2013 22:55 pm
- Hardware/Software: Mircoturn and Micromill
Re: Denford 2000 Blown Baldor Board
You could send the board to Digikey and have them repair it. I sent mine to Drive Controls in Toronto and they sent it to them.
Steve
Steve