Drawings for nuts to fit the M1, Major & VS models - request was made for information on the Yahoo Tom Senior group.
Apologies for quality / file size - there was a lot of stuff to get through the day I found these!
Andy
TS Cross-slide and feed nut drawings (Metric)
Moderators: Martin, Steve, Mr Magoo
-
Andy B
- CNC Guru
- Posts: 396
- Joined: Mon 20 Nov , 2006 18:19 pm
- Hardware/Software: 280 VS lathe, Denford Senior E-type mill, Senior Major Universal Mill
- Location: East Midlands, UK
TS Cross-slide and feed nut drawings (Metric)
- Attachments
-
- Cross slide nut
- DS 224 M Cross slide nut.jpg (1013.23 KiB) Viewed 13600 times
-
- Feed nut
- DS 39 M Feed nut.jpg (1.02 MiB) Viewed 13600 times
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: TS Cross-slide and feed nut drawings (Metric)
I've put them into a (hopefully) more manageable PDF:
- Attachments
-
- TS_Cross-slide_and_feed_nut_drawings_Metric.pdf
- (1.94 MiB) Downloaded 1284 times