Zerocentre Diagnostic Parameters
Posted: Mon 02 Dec , 2013 9:44 am
Gibo has been running his machine quite happily until a week ago when it lost all its memory.
We have reloaded all system parameters OK.
I have gone through the ladder diagram supplied in the manual and found the 400 series diagnostic parameters, but we do not have a list or description of them, I think there may also be some timers to set in the 300 range?
Does anyone have a listing and is it possible to get a digital display? Fanuc parameter 19 bit 7 does not appear to have an effect.
His machine is serial number 8075555 with a FANUC 0M B.
We have reloaded all system parameters OK.
I have gone through the ladder diagram supplied in the manual and found the 400 series diagnostic parameters, but we do not have a list or description of them, I think there may also be some timers to set in the 300 range?
Does anyone have a listing and is it possible to get a digital display? Fanuc parameter 19 bit 7 does not appear to have an effect.
His machine is serial number 8075555 with a FANUC 0M B.