VMC1300 spindle doesn't spins
Posted: Wed 25 Apr , 2018 22:29 pm
Machine was running correctly but when we started a new milling spindle didn't turn.
It did just about 90 degrees turn and stopped.
We disconnect servomotor (BALDOR) from spindle and it still happens which means problem is between electrical command or encoder or servomotor.
We are planning check each one meanwhile we would like to know if someone here had this problem and how it was solved.
Best regards
Andre Rocha
It did just about 90 degrees turn and stopped.
We disconnect servomotor (BALDOR) from spindle and it still happens which means problem is between electrical command or encoder or servomotor.
We are planning check each one meanwhile we would like to know if someone here had this problem and how it was solved.
Best regards
Andre Rocha