I am in need of a little advice.
My vmc 1300 developes a clicking noise from the spindle area as the head heats up on a long job. When it's cooled down its smooth again.
Is this a serious fault?
I can't see a grease point anywhere, bearings and belt are hidden inside the castings.
Are they tapered bearings requiring adjustment?
Noisy spindle
Moderators: Martin, Steve, Mr Magoo
-
- Posts: 10
- Joined: Wed 19 Jun , 2013 18:34 pm
- Hardware/Software: VMC 1300
VR 5 virtual milling
-
- Posts: 10
- Joined: Wed 19 Jun , 2013 18:34 pm
- Hardware/Software: VMC 1300
VR 5 virtual milling
Re: Noisy spindle
Update on my spindle bearing noise, with advice from Steve at Denfords I have now changed the main bearings and after the first run it seems to be nice and quiet.
It took a week of careful work, made a few special tools and pondering how tight the bearing tension nut should be , as it will take a few hours to
get at it for adjustment if I have got it wrong.
It took a week of careful work, made a few special tools and pondering how tight the bearing tension nut should be , as it will take a few hours to
get at it for adjustment if I have got it wrong.
-
- Posts: 10
- Joined: Wed 19 Jun , 2013 18:34 pm
- Hardware/Software: VMC 1300
VR 5 virtual milling
Re: Noisy spindle
- Attachments
-
- 20220614_112044.jpg (304.8 KiB) Viewed 6468 times