Removing the guard

All info relating to the Denford VMC1300 and VMC1300 Pro CNC milling machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
johnparker
Posts: 23
Joined: Mon 16 May , 2016 20:18 pm
Hardware/Software: VMC 1300 Pro

Removing the guard

Post by johnparker » Sun 23 Dec , 2018 14:59 pm

I'm about to service my VMC 1300, and access to the rear grease points is a challenge! Removing the guard will give me a bit more room above the spine when I lean in to the cabinet. Any tips?
I'm going to source a grease gun too, any experience/tips will be appreciated. The small Hiwin nipples appear to be the tricky ones
Top
Post Reply

Return to “VMC 1300”