Hi All!

All info relating to Viceroy machines - Lathes, sharpedge, drills etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
AndyChapman
Posts: 1
Joined: Fri 07 Jan , 2022 17:56 pm
Hardware/Software: DST Viceroy lathe, model no. TDS4 P/L

Hi All!

Post by AndyChapman » Fri 07 Jan , 2022 18:16 pm

Hi, Newbie Here and thanks for letting me in! My bro' in law has a Denford Viceroy 440v lathe in his workshop and we are looking for a manual. It has TDS/4/ P/L stamped on the plate ( see image) Any info about this machine greatly appreciated and we are looking for a manual if one is in existence. Thanks in anticipation...Andy
IMG_1262.JPG
IMG_1262.JPG (113.08 KiB) Viewed 4084 times

LesT
CNC Expert
CNC Expert
Posts: 117
Joined: Wed 11 Aug , 2010 14:17 pm
Hardware/Software: An old Viceroy with a half installed invertor drive,(when I can decide where to put the control pushbuttons I will wire it up properly)
A WMD25V mini mill.
Tractor, Bobcat 320, and Dumper truck.
7 sheds, about 5 (?) mowers. etc, etc.
Location: Scotland !

Re: Hi All!

Post by LesT » Sun 09 Jan , 2022 14:02 pm

Hi,
Here's a link for a TDS 1 manual:

https://www.denfordata.com/pdfs/Viceroy ... -Lathe.pdf

Lathes.co.uk covers just about all lathes I think, see link below,

http://www.lathes.co.uk/viceroy/

The site site has a lot of information about Denford and Lathes in general.

Les.T.

Post Reply