Faceplate for Denford 280 Synchro

All info relating to Viceroy machines - Lathes, sharpedge, drills etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
rpwilson
CNC Expert
CNC Expert
Posts: 155
Joined: Tue 03 Jun , 2014 15:20 pm
Hardware/Software: None. I own a pre CNC Denford 280 Synchro lathe.

Faceplate for Denford 280 Synchro

Post by rpwilson » Tue 25 Feb , 2020 14:39 pm

Since I sold the Denford, I've got no further use for an 11" faceplate which I bought for it. Its got the D1-3 spindle nose fitting, and is much more capacious than the standard Denford faceplate offering. Its in good condition with no marks on it. I'm asking £35 collected from my house near Worcester, or plus postage at cost, probably about £10.
I've also got a set of 3 gears to fit the thread dial indicator, to suit both imperial and metric leadscrews, if anyone need them.
Email me direct on richardpwilson61@yahoo.co.uk


Richard Wilson

Post Reply