Servicing Viceroy TDS 22
Posted: Sat 20 May , 2017 22:30 pm
I have a Viceroy TDS22 Ser. No. 202/504 table drill with 3 phase motor running via a converter.
This is working well with little sign of wear but is somewhat noisy. I am planning to take it apart and service it and have downloaded the drawings from this forum - thanks! Any advice would be much appreciated before starting, especially what parts may be required, assuming still available.
Kind regards,
Sandy.
This is working well with little sign of wear but is somewhat noisy. I am planning to take it apart and service it and have downloaded the drawings from this forum - thanks! Any advice would be much appreciated before starting, especially what parts may be required, assuming still available.
Kind regards,
Sandy.