TDS 1/1 single phase wiring
Moderators: Martin, Steve, Mr Magoo
TDS 1/1 single phase wiring
Hi, I am converting my lathe to single phase, I have downloaded the wiring diagram for the TDS 1/1 and need some advice please, on the single phase wiring diagram it shows 4 wires going to the motor these are X,Y,B and A, does anyone know where these would be wired to on the motor side, my motor is a Brook Crompton with terminals marked A-Z-Z1 and S
-
LesT
- CNC Expert
- Posts: 119
- Joined: Wed 11 Aug , 2010 14:17 pm
- Hardware/Software: An old Viceroy with a half installed invertor drive,(when I can decide where to put the control pushbuttons I will wire it up properly)
A WMD25V mini mill.
Tractor, Bobcat 320, and Dumper truck.
7 sheds, about 5 (?) mowers. etc, etc. - Location: Scotland !