We have a SN 40 C T.D.S lathe and need a new chuck does anyone know where we could get one?
We have tired a couple of suppliers but they have supplied incorrect chucks.
the stamp on our current chuck says T.D.S 250/3-2 B6 2500mm 1
Where to get an SN 40 C chuck
Moderators: Martin, Steve, Mr Magoo
-
LesT
- CNC Expert
- Posts: 119
- Joined: Wed 11 Aug , 2010 14:17 pm
- Hardware/Software: An old Viceroy with a half installed invertor drive,(when I can decide where to put the control pushbuttons I will wire it up properly)
A WMD25V mini mill.
Tractor, Bobcat 320, and Dumper truck.
7 sheds, about 5 (?) mowers. etc, etc. - Location: Scotland !
Re: Where to get an SN 40 C chuck
I think there may be some mistake, the "SN40C" lathe appears to be manufactured by TOS.
Whilst I'm sure it is an excellent lathe, this is a Denford forum.
Perhaps someone may be able to help though.
Whilst I'm sure it is an excellent lathe, this is a Denford forum.
Perhaps someone may be able to help though.
-
FrederickS
- Posts: 2
- Joined: Wed 15 Mar , 2017 17:02 pm
Re: Where to get an SN 40 C chuck
LesT wrote:I think there may be some mistake, the "SN40C" lathe appears to be manufactured by TOS.
Whilst I'm sure it is an excellent lathe, this is a Denford forum.
Perhaps someone may be able to help though.
Apologies I had been told it was a denford lathe sorry about the confusion.