Page 1 of 1
Viceroy lathe nut wanted
Posted: Tue 01 May , 2012 17:30 pm
by gordon
Wanted. Cross slide nut for MK2 Viceroy lathe.
Serial number: 29515
Gordon.
Re: Viceroy lathe wanted
Posted: Wed 02 May , 2012 10:55 am
by Andy B
I can't help with a part - but do you want metric or imperial??
Andy
Re: Viceroy lathe wanted
Posted: Wed 02 May , 2012 18:57 pm
by Pete.
Gordon look up my previous post on how to make a new nut from acetal. Mine is still working perfectly with no back-lash.
Re: Viceroy lathe nut wanted
Posted: Fri 04 May , 2012 13:31 pm
by Denford Admin
The Delrin nut post is here:
viewtopic.php?f=4&t=3034
Does anyone know the author of the original "Making acetal nuts" post ? I wondered whether to copy the images into this forum for safekeeping...?
Re: Viceroy lathe nut wanted
Posted: Fri 04 May , 2012 18:23 pm
by Pete.
Denford Admin wrote:The Delrin nut post is here:
viewtopic.php?f=4&t=3034
Does anyone know the author of the original "Making acetal nuts" post ? I wondered whether to copy the images into this forum for safekeeping...?
The author is Evan Williams.
I'll ask hm if he's ok with it.
Re: Viceroy lathe nut wanted
Posted: Tue 08 May , 2012 10:20 am
by Denford Admin
As he said it was OK, I've copied the best bit from the other forum to here:
viewtopic.php?f=50&t=3727
Re: Viceroy lathe nut wanted
Posted: Sun 13 May , 2012 17:44 pm
by gordon
thanks for the replys on viceroy lathe nut
gordon