Page 1 of 1
Wanted wiring diagram for GSM PC 1001/F speed board
Posted: Thu 24 Mar , 2011 12:52 pm
by elderly
Hi. Has anyone got the connection details for the above board that fits into the control box for a Viceroy VS280 lathe, its the speed indicator display board?
I would like to know which is the power and the sensor connections if possible.
Re: Wanted wiring diagram for GSM PC 1001/F speed board
Posted: Thu 24 Mar , 2011 14:44 pm
by Denford Admin
Is it like this ?
viewtopic.php?f=50&t=1932
It looks like andyb might have the dwg SK601 - I can't find it here sorry.
Re: Wanted wiring diagram for GSM PC 1001/F speed board
Posted: Fri 25 Mar , 2011 12:48 pm
by Andy B
A photo of your board would be useful just to confirm its spec - in case it's another variant not seen before!
But on both boards shown in the thread that Admin suggested, the left-hand pair of connections (as viewed in the photos on the solder-side of the connector block) are for power. You should be able to trace the tracks to 4 diodes or a rectifier.
The next pair in are the sensor.
The last four are for the LED's - as can be seen by following the tracks through the voltage drop resistors.
Andy
Re: Wanted wiring diagram for GSM PC 1001/F speed board
Posted: Fri 25 Mar , 2011 12:56 pm
by Andy B
Admin - can this thread be moved to the Viceroy section?
Andy
Re: Wanted wiring diagram for GSM PC 1001/F speed board
Posted: Fri 25 Mar , 2011 14:05 pm
by Denford Admin
Yes - I thought about moving, but wondered if the OP was offering to pay for an original wiring diagram (maybe to boost interest??)
Re: Wanted wiring diagram for GSM PC 1001/F speed board
Posted: Fri 25 Mar , 2011 19:52 pm
by elderly
Hope these photos help
Re: Wanted wiring diagram for GSM PC 1001/F speed board
Posted: Fri 25 Mar , 2011 21:45 pm
by Andy B
Thanks for the pix - looks identical to the 'type 1' photo in the other thread.
So connections are definitely as given above.
Andy
Re: Wanted wiring diagram for GSM PC 1001/F speed board
Posted: Sat 26 Mar , 2011 10:07 am
by elderly
Many thanks Andy, I will try it out.
Thanks Ken