Model:TDS/C/R/CNC - spindle problems
Posted: Tue 08 Feb , 2011 6:34 am
Customer writes ......
Hi
New to this site.
We have a problem with the speed contol on our lathe.
Model:TDS/C/R/CNC (Feb 1985)
When in manual mode, the spindle will start, however when we try to vary the speed, via the +ve / -ve keys on the spindle speed section of the keyboard, there is no response in either direction.
At present the spindle speed is varying (self-fluctuating) between 100RPM & 120RPM.
Does anybody have a solution?
Thank You
Martin
Hi
New to this site.
We have a problem with the speed contol on our lathe.
Model:TDS/C/R/CNC (Feb 1985)
When in manual mode, the spindle will start, however when we try to vary the speed, via the +ve / -ve keys on the spindle speed section of the keyboard, there is no response in either direction.
At present the spindle speed is varying (self-fluctuating) between 100RPM & 120RPM.
Does anybody have a solution?
Thank You
Martin