Denford Software & Machines

Posted: **Tue 05 Oct , 2010 14:30 pm**

Customer Writes ..............

Hi

New to this site.

We have a problem with the speed contol on our lathe.

Model:TDS/C/R/CNC (Feb 1985)

When in manual mode, the spindle will start, however when we try to vary the speed, via the +ve / -ve keys on the spindle speed section of the keyboard, there is no response in either direction.

At present the spindle speed is varying (self-fluctuating) between 100RPM & 120RPM.

Does anybody have a solution?

Thank You
Martin

Posted: **Wed 06 Oct , 2010 9:42 am**

What is a TDS/C/R/CNC?
Is it an Easiturn / Micromaster?

Picture of the machine might help to at least find manuals / schematics.

Andy

Posted: **Wed 13 Oct , 2010 8:59 am**

Just a couple of quick questions.

Have you messed around in the front panel of the machine recently? There is a 2 core ribbon cable that plugs in to P2 on the TIO.C board. If it is removed & refitted upside down then you get the same symptoms as you are reporting)

Do the buttons beep when pressed?

We also have a section on the Denford Forum for the Orac which may be of help. viewforum.php?f=43&start=0

Posted: **Wed 13 Oct , 2010 9:01 am**

Denford Software & Machines

TDS/C/R/CNC (Feb 1985) ORAC Lathe - Speed control problem

TDS/C/R/CNC (Feb 1985) ORAC Lathe - Speed control problem

Re: TDS/C/R/CNC (Feb 1985) Lathe - Speed control problem

Re: TDS/C/R/CNC (Feb 1985) Lathe - Speed control problem

Re: TDS/C/R/CNC (Feb 1985) Lathe - Speed control problem