- IMG_1262.JPG (113.08 KiB) Viewed 8967 times
Hi All!
Moderators: Martin, Steve, Mr Magoo
-
AndyChapman
- Posts: 1
- Joined: Fri 07 Jan , 2022 17:56 pm
- Hardware/Software: DST Viceroy lathe, model no. TDS4 P/L
Hi All!
Hi, Newbie Here and thanks for letting me in! My bro' in law has a Denford Viceroy 440v lathe in his workshop and we are looking for a manual. It has TDS/4/ P/L stamped on the plate ( see image) Any info about this machine greatly appreciated and we are looking for a manual if one is in existence. Thanks in anticipation...Andy
-
LesT
- CNC Expert
- Posts: 119
- Joined: Wed 11 Aug , 2010 14:17 pm
- Hardware/Software: An old Viceroy with a half installed invertor drive,(when I can decide where to put the control pushbuttons I will wire it up properly)
A WMD25V mini mill.
Tractor, Bobcat 320, and Dumper truck.
7 sheds, about 5 (?) mowers. etc, etc. - Location: Scotland !
Re: Hi All!
Hi,
Here's a link for a TDS 1 manual:
https://www.denfordata.com/pdfs/Viceroy ... -Lathe.pdf
Lathes.co.uk covers just about all lathes I think, see link below,
https://www.lathes.co.uk/viceroy/
The site site has a lot of information about Denford and Lathes in general.
Les.T.
Here's a link for a TDS 1 manual:
https://www.denfordata.com/pdfs/Viceroy ... -Lathe.pdf
Lathes.co.uk covers just about all lathes I think, see link below,
https://www.lathes.co.uk/viceroy/
The site site has a lot of information about Denford and Lathes in general.
Les.T.