I am walid from egypt cairo
I want to know
Are any one set up dro readout axis in his lathe viceroy 280 vs
I want to do
But I am feared from oversize linear scale
Pleas any one have a experience with some photos if you can
Dro readout 3 axis for viceroy 280vs
Moderators: Martin, Steve, Mr Magoo
-
Walid
- Posts: 11
- Joined: Mon 29 Oct , 2018 4:22 am
- Hardware/Software: Vicroy 280vs wathauot converter
Dro readout 3 axis for viceroy 280vs
Hi
I am walid from egypt cairo
I want to know
Are any one set up dro readout axis in his lathe viceroy 280 vs
I want to do
But I am feared from oversize linear scale
Pleas any one have a experience with some photos if you can
I am walid from egypt cairo
I want to know
Are any one set up dro readout axis in his lathe viceroy 280 vs
I want to do
But I am feared from oversize linear scale
Pleas any one have a experience with some photos if you can
-
dazz
- CNC Expert
- Posts: 246
- Joined: Sat 19 Aug , 2006 11:31 am
- Hardware/Software: Viceroy TDS 1/1GB lathe, Imperial, stripped down and rebuilt.
Viceroy Taper/Tracer attachment, Shop made cross slide tracer attachment, VSD. - Location: New Zealand
Re: Dro readout 3 axis for viceroy 280vs
Hi
If you use a system based on magnetic tape scale, like this one:
https://www.aliexpress.com/item/1005001 ... mainSearch
You can cut the tape to length.
Adding a DRO is quite a complex project so look at what others have done on similar lathes.
If you use a system based on magnetic tape scale, like this one:
https://www.aliexpress.com/item/1005001 ... mainSearch
You can cut the tape to length.
Adding a DRO is quite a complex project so look at what others have done on similar lathes.
Regards
Dazz
Dazz